Subject: Slide throttle: Needed with carb?
From: Rotary Engine
Date: 11/12/2009, 8:13 AM
To: AAA Put this in the To box


I'm fairly sure I'm going to eventually go with a simple mechanical carb with manual
leaning (as we discussed a while back).  If so, what's the likely penalty
(HP/weight/fuel consumption) for using the built-in throttle on the carb rather than
going with the more efficient slide throttle for a NA 13b P-Port setup?
Thanks

Mark W.
                         

I don't know Mark but my guess is not much.  The big problem with a 13B p-port and carb
is idling stability. You need the throttle close to the rotor housing. With an RX8 side
exhaust it would be just as  stable as a side intake 13B.

---------------------------------------------------------------------

Another problem you will have to deal with is stand off fuel vapor. With any tunned
system air flows both in and out of the carb. At around peak torque plus or minus 1000
RPM lots of fuel vapor is generated outside the carb as the air flowing out of the carb
also sucks fuel out of the venturi. You can see this in our Youtube video Using a weber
carb.

http://www.youtube.com/watch?v=LkKw72dZ2yc
http://www.youtube.com/watch?v=KQL45DYgIFw

We checked for this with fuel injection on Marks Suspinski's engine and it does not happen.

You will have to deal with this fuel vapor with a sealed air box above the carb to make
sure all the fuel vapor is captured. I am not sure how much of this happens if the air
box is provided with ram air at cruising speed. I suspect the phenomena is much reduced.
Sorry but you will be on the cutting (bleeding?) edge.

Here are some 3D's of a system using a Holley 500 CFM two barrel carb with leaning block.

Paul Lamar

***********************************************************
Paul,
 Thanks very much.  Yes, something will have to be done about the fuel vapor "outflow".  I think the ram air might help hold things inside an air box at cruise speeds, but on takeoff it wouldn't be much help.  Maybe (at cost of some efficiency) go with a carb location closer to the engine and tuned pipes before<< the carb?  I'm sure the change in intake diameter through the carb will eliminate the chance to get a constructive standing wave from the intake port to the bel mouth, but maybe a constructive wave from the carb to the bell mouth could be set up with the right runner lengths.
  Or maybe intake length tuning is too much trouble for my simple application.  I'll already have more HP than the plane is designed for, and simplicity and weight are both important factors.  Maybe for me the best option is an air box fed by ram air, convenient length runner to the carb, convenient length runner to the engine.

Mark W.

There is limited room to put the carb closer to the rotor housings.
You could lose 50 HP in a p-port config and more in a side intake port config.   
Early 13B's with 4 barrel carbs were 145 HP.

What kind of aircraft are you building?

Paul Lamar                   

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.