I am looking at picking up a Cessna 337 Skymaster for our project -
Skymaster 336 may also do but is light on useful load for our purposes.
The
337 C and D models look like they have the highest useful loads.
We would replace the 2 x 210 Hp Continental IO 360 engines with 2
rotaries
of equal or higher hp but with the emphasis on higher turbo normalized
altitude capability. Losing the FAA type rating is not an issue for us.
Any ideas on the firewall forward weight of the Continental IO360 at 210
hp.
I am hoping for a weight savings after rotary install to increase our
useful
load. Thanks
Brian Feeney
DreamSpace Group
There won't be much weight savings unless you get aluminum end housing.
If you do that you might save about 100 pounds per engine.
Paul Lamar
The small Continental (IO-360) is quite heavy, being a 6 cylinder..
Maybe 50lbs heavier than a parallel valve 4 cylinder Lycoming (O-320,
O-360).. I believe the installed weight of the Continental may be
somewhat heavier than the angle valve 4 cylinder Lycoming (IO-360).
http://www.aviator.cc/aircraft_engine_weights.html
There are STC's to convert the Skymaster to using twin turbocharged
IO-550's.. The airframe can (be made to) handle the weight.
http://www.aviationenterprises.us/engineconversion.html
Matt-
I have it as 327 pounds.
http://www.rotaryeng.net/all-aircraft-engine-weights.txt
Paul Lamar
NASA did this in the 80's. They put a rotary in the front with a belt drive
and left the Continental on the rear. The program was cancelled just before
first flight.
Joe Berki
Limo EZ
Mistral envisaged to convert a Skymaster as a test-bed aircraft for its
engines. It looked like the ideal airframe for it. After an in-depth study,
Mistral decided against the Skymaster for 2 reasons:
1. The Skymaster's front-engine mount is integral to the airframe and
adapted only to the TCM IO-360. Mount changes are possible and have been
made, but it is a huge and engineering-wise very delicate job, without even
the need to STC it. The rear-engine mount is a steel-tube mount, no problem
to adapt a rotary there but:
2. If you have an O-engine upfront and a rotary in the rear, prop rpms are
(a priori) not matched and that would create significant problems.
Conclusion: The Skymaster looks like a great airframe to re-motorize... but
the devil hides in the details.
Take care,
François Badoux
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.