Paul,
You mentioned previously that you would not make a slide throttle kit for
the 20B but you could supply some of the raw materials for us to make our
own.  What parts do you have (ie.tubes, plate material, etc) that we can
 use
and what are the costs?  I found a 20B slide  throttle drawing on your
website and was going to start searching for  someone who can do the
fabrication
for me, but I thought it might be better to  start with any parts that
you've already got rather that trying to start from  scratch.

Don

The only thing I have is the fuel injector blocks and the bell mouth.
Bob Darrah may have built some parts for Mark Steitle. Bob is building a 3
rotor Sea Wind and Mark is installing a p-port 3 rotor in his Lancair ES.
Both are in Austin.

Paul Lamar

Paul,
You also supplied me with the inlet/outlet tubes.  BTW, I still need tube #6
(You may remember that it wouldn't fit in the box).  I may have enough
teflon left over to make one more 3-rotor slide throttle, but can't be sure
until I see if I screw up the first one.  ;-)  Aluminum is easy to come by.

Mark S.

Yes I forget about those. I have a few left at $20 each. Cash.
Picture on the web site. Send the money to:

830 East Santa Maria St.
Suite 303
Santa Paula CA
93060

This is not a shipping address. Mail only.

BTW one could get two slide throttle kits and kludge them into a 3 rotor version with a bit of tig welding. I think but I am not sure :)

Paul Lamar