Subject: Oil filler tube
From: Rotary Engine
Date: 11/16/2009, 7:33 AM
To: AAA Put this in the To box



Does  anyone have a trick for extracting the oil filler tube out of  the
intermediate housing?  Thanks for any help.

Joe  Berki



Install a worm style hose clamp around the filler pipe about 1 1/2" above
the iron. Place a socket on the iron as a fulcrum. Use a giant screw driver
(or  similar) as a lever to jack the filler tube out of the iron. Move the
hose clamp  down as required. Discard the hose clamp.

To reinstall the filler pipe, coat the end with non hardening Permatex.
Place a wood block over the cap end.
Strike with a heavy slow moving weight. Usually one stroke puts it back.

The filler necks on early engines are steel. They can be shortened. Baffles
may be installed. Breather fittings may be brazed or welded in place. I
install  a tab at the base and secure the pipe to the iron with a screw
threaded into the  iron.

The hole may be closed off and the distributor hole used for breathing if
no distributor or angle sensor is used. (probably a bad idea for aircraft
use).

An aluminum bung or plug should use an "O" ring seal and a threaded
fastener to lock the bung in place.

The outer wall of the hole is too  thin to be pounding in solid plugs,  and
may crack out during the operation, or worse, at a later time.

Lynn E. Hanover


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.