Subject: End and intermediate housings
From: Rotary Engine
Date: 11/19/2009, 6:48 PM
To: AAA Put this in the To box



When rebuilding the 2nd gen do the cast iron housings need any treatment or
can they be used as is?  Cylinders in a piston engine are usually honed so
new rings can seat what about side seals? Thanks for any help

Joe Berki

If they past the wear test in the shop manual they are OK. If not they must be lapped. If more than about .003" as I recall needs taking off to get rid of the ridges  they must be  surface hardened with the nitride process.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.