Subject: p-port rotor housings are shipping
From: Rotary Engine
Date: 11/24/2009, 8:48 PM
To: AAA Put this in the To box

Send me your shipping address as the rotor housings will go out soon to
those
that have already sent the money. Best to include a label when you send
money.

For those that have not send $350 cash. no check no money order or no
credit
cards. Green stuff only. That is $150 each for the rotor housings and $50
for
shipping anywhere in the US to keep it simple. Except perhaps Alaska or
Hawaii :)

send it to:

Paul Lamar
830 East Santa Maria St
Suite 303 Very very Important.
Santa Paula CA
93060

You can send it registered if you wish.

Paul,
$ will be on the way.  What should we use for filling the end and
intermediate housings?  I think Masdatrix or Racing Beat sells some Devon
stuff for $50.00.  Their site indicates that you build a dam out Al foil how
far in?  It stays in the housing? Any issues with this?

Joe Berki
Limo EZ


Paul, I think Joe's question is how to fill the factory side port
openings in the irons which are no longer used. I would also like some
options on this proceedure.
george grimes

Right my mistake. Thanks for catching that George

Silicone rubber has been used. Also JB Weld works
fine. Leave a little depression in there to vent any pressure differences.

Paul Lamar



The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.