Subject: p-port rotor housings are shipping
From: Rotary Engine
Date: 11/24/2009, 10:43 PM
To: AAA Put this in the To box


 Send me your shipping address as the rotor housings will go out soon to
 those
 that have already sent the money. Best to include a label when you send
 money.

 For those that have not send $350 cash. no check no money order or no
 credit
 cards. Green stuff only. That is $150 each for the rotor housings and $50
 for
 shipping anywhere in the US to keep it simple. Except perhaps Alaska or
 Hawaii :)

 send it to:

 Paul Lamar
 830 East Santa Maria St
 Suite 303 Very very Important.
 Santa Paula CA
 93060

 You can send it registered if you wish.

 Paul,
 $ will be on the way.  What should we use for filling the end and
 intermediate housings?  I think Masdatrix or Racing Beat sells some Devon
 stuff for $50.00.  Their site indicates that you build a dam out Al
 foil how
 far in?  It stays in the housing? Any issues with this?

 Joe Berki
 Limo EZ


  Paul, I think Joe's question is how to fill the factory side port
  openings in the irons which are no longer used. I would also like some
  options on this proceedure.
 george grimes

 Right my mistake. Thanks for catching that George

 Silicone rubber has been used. Also JB Weld works
 fine. Leave a little depression in there to vent any pressure
 differences.

 Paul Lamar


Most people fill the side ports with epoxy of some sort.
More than a few pport engines have died an early death due to epoxy plug
ingestion.

Be certain the epoxy plugs are well below the running surface of the
side seal, so it can not expand into the chamber under temperature.
You probably also want to secure the plug somehow (rebar?).
You might also consider the effects of thermal cycling and poor or
contaminated epoxy bonding which could also send bits into the engine
proper, likely damaging side/apex seals. (probably off the end of the
runway on climb-out)

As an alternative, you might consider aluminum tube inserts.  The ones
in picture were stock sized AL tubing  leftovers I had lying around
(sorry, can't remember the size).  The round end housing ports were an
easy hacksaw / hand file fit with a few iterations of test fitting.
IIRC, I used the same left-over tubing for the center irons plugs.  They
were formed with a lack of care in a vice, cut and filed to a near
perfect fit.
The whole effort was a few hours total and these will never fall into
the engine.  Seal the airflow as you see fit.

Cheers
Cary

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.