Subject: Mechanical/electric fuel injection sort of
From: Rotary Engine
Date: 11/26/2009, 7:16 PM
To: AAA Put this in the To box


I had a talk with a Sprint car mechanic recently and mechanical fuel injection is widely used in 800 HP Sprint car engines. Kinsler is a major supplier of parts. What I am thinking of doing is use a pulse width controlled electric fuel pump instead of the engine driven Kinsler fuel pump. My friend tells me there is a thing called a "pill" that bypasses the fuel back to the tank. The size of the hole in the "pill" controls the max pressure the fuel rail sees.

What happens with fixed orifice injectors is the fuel pressure goes up as the volume of fuel going through the injectors increases. Sprint car drivers are not allowed to change the "pill" while driving but a needle valve on the instrument panel could serve the same purpose. This is a super simple fuel injection system and super low cost as one needs a fuel pump in any event. The 555 circuit I have will work as is to control the pump speed based   on either manifold pressure sensor output  or mass air flow sensor output.

I just checked an electric  pump I had to verify the housing of the pump was electrically isolated from the negative side of the motor connector. This is a long story  as the PWM circuit switches the low side of the load just like a fuel injector. One of those little details one must worry about.

The first option is the cheapest as the sensors cost about $10 while the second can cost up to $100. The manifold pressure sensors are linear while the mass air flow sensors seem to put out a square law voltage with air flow. I am not sure about that statement as I have not extensively tested one yet. That I can do by sticking it out the window of a moving car and recording the voltage out as a function of car speed.

The first configuration tested will be the pressure sensor as a low cost hand vacuum pump can be used to simulate the manifold pressure over a wide range.

BTW I suggest everybody install Quick Basic on their windows computer as I will be using it a lot in the future to calculate various and assorted things as it works well for doing this. Easy to learn but if your ISP will not pass a zip file, that I can send you, then you will have to send me $5 for a DVD. Included in these attachments is a picture of a QB program to calculate the fuel flow through an orifice. You can just type it in by looking at the picture.

A spread sheet will also work but I am not as quick using them as I am QB.

Paul Lamar

Hi Paul, Craig Taylor here.

Here is a thought.  Add a fuel accumulator and Use a fuel pump with a check valve to charge an accumulator. Design the accumulator like a hydraulic accumulator, with a head of compressed air and a diaphragm separating the fuel and air.  Now measure the pressure of the air and you know the fuel pressure.  Air pressure measurement is cheap, as you know.
You then vary the power to the fuel pump to keep the air (and fuel) pressure constant.  Or vary the fuel pressure, if desired.
With controlled fuel pressure you can run a fixed orifice, constant flow system OR use a pulse width regulated valve for faster or more precise control.
For fail safe, have a dash switch that bypasses everything electronic and applies direct battery power to the fuel pump. Possibly install a pressure regulator valve to bypass the fuel back to the tank at some "higher than normally expected" pressure.
This approach bypasses both the high fuel flow problem of the typical "bypass regulator" constant pressure fuel supply system and also allows electronic control of the fuel pressure.  Should be cheap to implement.  The pressure accumulator is the only somewhat costly part.  I would use a "rolling diaphragm" to separate the fuel and air to allow several liters of fuel in the accumulator for emergency fuel supply if the fuel pump quits.  Also permits the fuel to be delivered at any attitude.

Craig Taylor


Interesting idea. Thanks.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.