Subject: All you need to know about everything!
From: Rotary Engine
Date: 11/27/2009, 9:42 AM
To: AAA Put this in the To box

I guarantee you will generate less HP as the velocity of the intake air going
through the runner will increase and the skin friction drag inside the runner is
proportional to the air velocity squared! The velocity of the air at a given
volume flow is proportional to the cross sectional area of the runner. This
would be a good problem for a QB program.

Read this news letter for ten years and you get an automatic phd in engines :)

Paul Lamar

--------------------------------------------------------------------------
I wonder if the higher V of the smaller pipes might not result in slightly greater "packing" of the air charge into the chamber.  It would not be enough to make up for the greater friction you describe, but it offsets things a little.

Very true!  I've still got some GI Bil eligibilty left--If you could just get this newsletter accredited as a VA-sanctioned course and give us a test now and again, I think Uncle Sam would send you a check every few months. :)
              
Hmm, I'll bet the shorter runners of smaller diameter would weigh about 40% less.  Not a big deal in the grand scheme of things, but every pound counts. Again, probably only woth the HP loss in a very unusual application.
Mark Waldron
       
----------------------------------------------------------------
The wall on that aluminum tube is .065".

40% less than .9 pound? :)  .36 pound savings  per runner ? :)

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.