Subject: Coils and spark plug wires
From: Rotary Engine
Date: 11/27/2009, 9:34 AM
To: AAA Put this in the To box

   Paul,

 Am I safe in assuming that the stock Mazda coils are all the same?

 And, likewise true for the spark plug wires?

 Thanks,

 Sandy McNabb
 Renesis in a Glass Goose

 Coils are coils for the most part but some coils have different turns ratios for
 higher voltage sparks. I can't say which is which but MSD and others sell higher
 voltage coils. A lot depends on the ignition system used. Coils used to be on
 most of the time and the points turned them off to generate the spark. Newer
 systems use transistors that may not switch the same speed as points. CD systems
 use pretty much the same coil but it is used differently as a pulse transformer.
 A narrow high voltage pulse somewhere in the neighborhood of 300 to 400 volts is
 used to shock the coil into action and output a spark.

 I would not say that for spark plug wires. Some use radio noise suppression
 carbon cores or some such. Aircraft spark plug wires are shielded. I don't think
 they use carbon cores but I could be wrong. I think Klause uses solid copper
 core wires but he has added a braided steel shield for radio noise suppression.
 I would try  TV coax cable or some such for spark plug wires but I don't
 guarantee the results as the insulation may not be up to the job.  Great Plains
 aircraft sells steel shields for automotive spark plugs used on VW engines.
 Contact them. http://www.greatplainsas.com/ Tell Steve Paul Lamar sent you :)

 Paul Lamar

Paul,

RG59 dielectric is only rated for 2300V maximum before breaking down. Last thing I'd use for spark plug wire!

To reduce RFI either resistor plugs with solid copper spark plug wire, or magnetic suppression wires with non-resistor plugs.

As to coils, most electronic systems have built in current limiting so you do not saturate the core. Faster cycle times.
Old point style coils had either internal or external resistors for current limiting.

Tom W

What about Teflon insulated coax? Would you have to go up to type "N"?

Speaking of ballast resistors the 2nd gen RX7 failed when used in aircraft use so the power rating of the resistor had to be increased. It was an electronic type with a crank angle sensor.


Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.