Subject: I am thinking of building some RX8 mufflers.
From: Rotary Engine
Date: 12/3/2009, 7:08 AM
To: AAA Put this in the To box


  Is anybody interested in buying some RX8 mufflers.
  It will look something like this but better workmanship
 :)
  I could also make a kit if you can weld.

  The stock RX8 exhaust header can not be turned around.
  It comes out on the wrong end for a tractor.

  Paul Lamar

 Hi Paul,

 Great!  I've been hoping someone would start making
 components for the RX8. Would this be a true muffler with a
 baffle configuration inside?  I would be very
 interested in one for my 6 port Renesis depending on
 cost.  Could you please post some more info on this.

 PS: Would be great if someone would offer a bolt on intake
 as well for the RX8 for some of us that don't want to go
 with a P-port.

 Thanks,
 Bob Forbes
 Upstate NY

 No baffles inside. Every piece of metal will be exposed to
 the air on one side for cooling purposes. Any time you put
 some baffles inside you risk melting the baffles and
 restricting the flow causing a loss of power.

 Something like this.


 Paul Lamar
----------------------------------------------------------------

While on the topic of mufflers, is the "cooling tube" that runs through the main chamber a necessity? Has it been documented to have a beneficial effect?
C. Smith

-----------------------------------------------------------------

No not tested for noise reduction. It is done on theory alone.
See the message I just sent.

I will say they have been tested with out the center tube and the 13 B's are a bit too noisy with 2 inch down pipes. I figure I will reduce the down pipe to 1.5 inches. The RX8 engine is another matter as it is quieter to begin with due to the side exhaust ports.

Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.