BTW do you know anybody making RX8 exhaust flanges? I am thinking of
getting a batch made up.
Paul Lamar
Racing Beat and Mazdatrix list the RX8 exhaust flanges, probably
Mazdaspeed as well.
Cheers
Cary
I found some headers but they won't work in tractors. No flanges for
the block outlets however. Do you have the right links?
Paul Lamar
Some others - notice the part#'s are the same :) - there may be a stock
mazda part as well N3H1-13-461B - don't know:
http://www.mazdatrix.com/8exhaust.htm
http://atkinsrotary.com/store/catalog/Exhaust-Flanges-title0-p-1-c-673.html
http://www.racingbeat.com/resultset.asp?PartNumber=16169
http://www.racingbeat.com/resultset.asp?PartNumber=16168
~C
Paul, If you do an exhaust flange for RX7 and one for RX8 shouldn't we be
using a CNC plasma cut 321 stainless flange. Also a slightly larger area
around te port would allow the stock double wall exhaust header to be used.
For a tractor installation after cutting off the cast iron flange and intake
port heating supply piece, turn the header upside down so that the outlet
faces the accessory end made possible by the equally spaced rectangular port
openings. I have not done this yet but plan on doing it by first adding
1-1/4" to the exhaust tube, then welding that assembly onto the flange and
finally adding a split extension to the outer cover and welding that to the
flange. This is intended to add support to the exhaust connection and reduce
temperature stress during cooldown by slowing the cooling rate, hopefully
preventing exhaust cracks. Also I am just too cheap to throw away such a
nicely made stock part, and every one I have came with the header attached.
george grimes
Surprisingly you don't need SS for exhaust flanges. Mild steel works fine
because they are so thick. I am building a tangential muffler so the stock
RX8 exhaust manifold is of no use. The input to my tang RX8 SS muffler will
be telescopic rectangular fabricated tubing.
Paul Lamar
Not only is it so thick, it's bolted to the engine with lots of
contact area, and since the engine is water cooled, the flange can't
get that hot.
Similarly, header wrapping tape, which causes the exhaust pipes to run
hotter than if they were exposed to air, can also cause increased
engine temperature and increased cooling system load. The pipe runs
hotter and that heat is easily conducted back to the engine - most
noticeable on an air cooled engine. The ceramic coatings (I know Paul
is skeptical of their capability) which are applied to the inside and
the outside of exhaust headers don't cause this issue.
Matt-
I don't mind ceramic coating on exhaust pipes because if it comes off it cannot
destroy the rotor housing wear surface unlike ceramic coatings on rotors.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.