Subject: On several completely different topics
From: Rotary Engine
Date: 12/5/2009, 8:19 AM
To: AAA Put this in the To box

          On a completely different not I am going to attempt to attach a
picture from the PPRE site which shows their take on placement of p-port
injectors and answers someones question about a throttle plate within the
tuned length intake tube. Take a look at the inline waterpump!!!!!!! looks
light and could be mounted at the exit of the radiator for the same reasons
fuel pumps are located in the tanks of modern cars. They might be on to
something about ramming the waterpump at it's optimum RPM independant of
e-shaft RPM. They have also apparently been able to add a stationary gear
and bearing to a 13B center housing although a custom e-shaft is required.

george grimes

Focus George :)
The picture did not attach. What email software are you using?

Rotaries for the millionair.

http://www.pulseperformancere.com/prodpack.html

The New Zealand Dollar is 72 cents U.S. so the prices are not quite as bad
as
they look.

I like their way of looking at things :)

Putting the butterflies there destroys the organ pipe tuning effect and the
idle.

The water pump should be mounted much lower. I can't tell anything about the
pump from looking at the picture. It does not look like a centrifugal pump.
How is it driven? If electric it is not up to continuous high HP use.

Here are some pictures from the web site.

Paul Lamar

-- 
Got to admit that the 'rear ends' of that model really look good!
Marc



-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.