I downloaded the stewart water pump catalog. The inline pump is a
brushless computer controlled pump rated at 55 GPM and is used as a booser
pump. For situations like mine with the mustang type radiator location 7'
behind the engine being able to push the water to the engine water pump
would be really advantageous.
george grimes
How much current does it draw?
Paul Lamar
Paul, The catlog doesn't list the current draw of the stewart inline
pump.The current draw is related to both flow volume and pressure rise
across the pump. In a cooling system the system is pressirized from a low
of13PSI to a high of 40PSI due to the heating of the water and expansion
of the air in the expansion tank. This inline pump as with the automotive
pumps are really circulation pumps and only have to provide enough pressure
differential to move the water through the system. Having a booster pump
delays the point where cavitation in the automotive pump starts and reduces
the HP draw on the engine mounted pump.
It will still take similar HP but
just devides the load. A single v belt transmits at best 5HP so the pump is
less than that, still a lot of electric draw. The common zoller basement
sump pump pushes 12 feet of head and flows 80GPM running on a wire size of
#14 which is 15 amps max, at 9 times our voltage or roughly 125 amps at 14
volts if the sump pump actually drew 15 amps which it doesn't ( actually 9
amps?) for about 81 amps at 80 GPM, less at 50 GPM the engine needs. It
seems like an 8 pound compound turbine impeller pump would boost cooling on
the gound and heat soak temp rise after shutdown and provide some flow if
the v belt breaks in flight.If the engine driven pump is providing flow
through the booster pump at 50GPM+ and the booster pump is spec'd at 55 GPM
the current draw (it is computer controlled) would be minimal and if over
55GPM goes through it might be possible to generate some electricity at
crusie RPM by running the leads through a bridge rectifier.
george grimes
110 volts AC is apples and oranges with 12 volts DC.
15 amps at 12 volts DC is 180 watts or .24 HP. Point two four HP.
a fraction of one HP. 746 watts is one HP.
15 amps at 110 volts DC is 2.2 HP!!! Something slightly different at 110 volts
AC but not far off.
The GPM flow is an inverse function of the resistance of the cooling system.
It is insufficient to quote the flow when the resistance of the cooling system
is not specified.
It says on the web site that it is not designed as a stand alone pump. It is
designed to supplement the water flow at idle. Which may or may not be a problem
on the rotary. One must instrument the rotor housing with a thermal couple to
find out. I suspect 90% of the problem mainly is the lack of air flow through
the rad core and not inadequate water flow. I could be wrong as higher water
transfers the heat to the rad core more rapidly perhaps lowering the temperature
of the water.
We have no evidence what so ever of cavitation in a rotary engine pump.
If you have cavitation in a pump you will not only hear it but the pump will be
damaged as well. I have seen several damaged water pumps that look perhaps like
cavitation damage. One was subject to low water levels and another due to pump
bearing failure.
This subject comes up over and over again. Hope springs eternal. It appears it
is approaching the status of a religion. The original development of the HP
concept was related to how fast a gallon of water could be raised from a mine
shaft. There have been no magic developments in water turbines in the last 200
years.
--------------------------------------------------------------------------
If water flow truly is a problem at idle and pump cavitation truly is a problem
at high RPM then a simple variable ratio water pump pulley like this will solve
the problem. The balls move out at high RPM squeezing the sheaves together and
reducing the drive reduction ratio so the pump does not over speed. Much cheaper
than an electric pump.
Patent applied for.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.