Subject: Cooling in the winter
From: Rotary Engine
Date: 12/14/2009, 3:29 PM
To: AAA Put this in the To box


Progress on the plane has been almost non existant for the last week or so because of the temperature, which has been in the teens and twenties. Global warming at it's finest. I did go out two days ago to run the engine for a while for a friend. After running it for between 10 and fifteen minutes at around 2500 rpm, I couldn't get the water and oil temps over 120 degrees f. I didn't want to run it up any higher until the oil got up over 130, which it didn't.  This is without the cooling scoop and exit flap completed. I have only to finish the cooling scoop (about 3 hours of work) and the exit flap (two hours), complete the air filter/plenum, and put on a transponder antenna, and this plane should be just about ready for inspection. Just running the engine at around 4000 rpm is almost scary because of the power available. First flight should be around March. Attached is an MS painted photo to show the proposed paint job.

Just waiting for warmer weather- at least 45 degrees so I can get back to work on this thing.

Brian Trubee

Looking good Brian. I love that cowl.

A one degreee change in outside air temp is a 1% change in cooling.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.