Subject: Stationary Gear/Bearing Set screw
From: Rotary Engine
Date: 12/18/2009, 5:10 PM
To: AAA Put this in the To box


I'm replacing the stationary gear main bearings. I have one done but on the
other two the small screws won't budge. I can tell the heads are going to
strip if I try to force them any more. As I was getting ready to drill them
out I wondered if maybe I could just use the hydraulic press to press the
bearing out and let the screw be sheared off. I had planned to replace the
screws anyway.

1) Anyone done this or is the risk of scratching the surface under the
bearing too great?

2) Is replacing these screws mandatory? Are the bearing fits not tight
enough to keep them in place? I'd hate to have one of these screws fall out
later.

Jay

Warm it in a kitchen oven to 500 F. That might kill any lock tight put on the screw. I would not press the bearing out with the screw in there. Try drilling and then use a eazy out to un screw it.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.