Subject: Cooling your oil in general
From: Rotary Engine
Date: 12/20/2009, 6:29 AM
To: AAA Put this in the To box

Modine has a great step by step out on how to select an oil cooler. It is 8 meg so I can't email it but I did just upload it to the web site. I suggest everybody download the pdf.

http://www.rotaryeng.net/Modine-calc.pdf

This is a real Christmas present for us as it takes some of the guess work out of choosing an oil cooler that works.

There is a some information you will need to know about the rotary.
You will need to know the HP you are trying to cool.
For that you need to look at this heat balance chart.

I have modified the chart to make it easy for a 200 HP side port 2 rotor but if you have a  p-port two rotor you will have to multiply the oil cooling HP number by 1.25. That means a 250 HP p-port engine running at best power mixture of 12.5 to one is rejecting 63 HP or 25% of the net HP out of the engine to the oil.
You then plug this number into the Modine equations to figure out the number of BTU's per minute you will be rejecting.

The next thing you will need to know is the GPM of the oil pump through the system. The stock number I think for the 2nd gen engine is 1.3 GPM at 1000 RPM.
At 7000 RPM it would be seven times that or 9.1 GPM. That number is somewhat dependent on the oil system plumbing and the size of the cooler. A larger cooler with more tubes is going to allow the pump to flow a bit more oil. Also right angles in the oil gallery of the engine also reduces the flow. More about that later. Lets say it is 10 GPM for a 2nd gen oil pump.

I think the 3rd gen pump is larger and the 3 rotor may be larger yet but I have no hard data yet. You will probably need to make some assumptions about that. Perhaps someone on here has measured the 3rd gen pump oil flow. I think Mistral did that and I may be able to find it.

Follow the first 3 steps in the pdf.

Note the lower the Viscosity of oil the better it cools. Use Idemitsu rotary engine oil. I used to use Mobile 1 SAE 15 weight for 15 years but I am now using Idemitsu. I think Mazdatrix sells it.

In Step 4 you enter the Modine chart called Curve 1 and you pick a LAB 130.
With a LAB 130 you will get a very low oil pressure drop across the cooler
amounting to only a few psi. A Lab 130 core is about 22 by 22 by about 2 inches thick. A smaller core will probably work as the airflow will be higher than what is called out in this PDF.

Continuing following the steps in the PDF to calculate the pressure drop.
What is missing here is the airflow data.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.