Subject: Aluminium rotor is on the market
From: Rotary Engine
Date: 1/7/2010, 9:29 PM
To: AAA Put this in the To box


Paul,
      After reading the article on rotaryeng.net rotor v piston which I
found very interesting.
      I thought you might like to know that the aluminium rotor you
mention as a possibility is a reality.

      Instead of 4.5 kg it's 1.5kg.

http://www.rotaryart.uk.com/acatalog/East_Coast_Parts_engine_tuning_acce
ssories.html#aECP_2dApexSeals13b
      The manufacturer reckons they've extracted 505hp in a series 6
rx-7 at 17psi on 93 octane pump pertrol.
      http://eastcoastparts.com/html/billet_rotor.html

Regards


Robert Williams

That is a solid aluminum and uncooled the last time I looked.
It is fine for under ten seconds in a drag car but I don't
think it will hold up in an aircraft application. They drove
it in a street car where the power is seldom over 40 HP.

I also kind of doubt the 1.5 kg weight claim. 7.35 pounds -.85 pounds
I think the weight will be closer to 6.5 pounds or 3 kg.

After all the cast iron rotor is hollow and there is a steel
phasing gear.

It is not so much the HP out as what is the maximum RPM
possible. 505 HP is nothing unusual for a turbo 13B. I would be
more impressed if they claimed 12,000 or 13,000 RPM on the dyno.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.