Subject: redrive conversion from 2.17 to 2.85
From: Rotary Engine
Date: 1/11/2010, 4:21 PM
To: AAA Put this in the To box


 Paul do you or anyone have plans or directions for converting 2.17
 redrive to 2.85 Tracey said I could buy the parts but no plans or
 directions I have local machine shop and can do some myself or might be
 that some on news letter do the conversion if I can get this solved then
 can look at one of the support plate as it sure looks very good

 Thanks Keith

 The problem is; you must get the power out of the planet
 carrier and lock the ring gear. It takes a different
 planet set to do that. The issue then becomes; is the housing
 small enough in ID to lock the new ring gear? Take your
 2.17 apart and measure the ID where the ring gear goes.
 Let me know what that dimension is.

 Paul Lamar
 -- Paul
 The ID of the housing that holds the ring gear is 5 1/8 ID the OD is
 6 3/8 Thanks for the help Keith


 The six pinion ring gear is about 5.023" OD so you will have to machine
 an insert and install it in the housing to lock the ring gear in place
 and take the power out of the planet carrier. The next issue is the
 spline of the planet carrier must match the spline on the end of
 the prop shaft. Measure the OD and count the teeth of that and let
 me know what that is. The six pinion planet carrier I have has a
 root diameter of 1.195" and an OD of about 1.320". There are 27
 teeth. If all that works you may still have to change the sun gear
 on the input shaft. The six pinion sun gear has an OD of 2.474",

 Paul Lamar

 Paul
 The prop shaft is 34 spline 1.484
 the sun gear and shaft one piece 34 teeth 2 8/64
 the planitary carrier is 6 gear
 Thanks Keith still cold in north TX.

 Paul  On Traceys part list he listed new input shaft and different
 sun gear and planitary carrier as it drives output-prop shaft what
 should I do with the housing holding the planitary carrier cut it
 down to use as spacer ?? I can email parts list Tracey sent

 Thanks Keith--

Yes it can be used as a spacer.

Good on the parts list send away. I'll look it over and
see what can be reused.

Paul Lamar


The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word UTUBPLEASE
Copyright 1998-2009 All world wide rights reserved.