Subject: aluminum wear surfaces
From: Rotary Engine
Date: 1/30/2010, 6:20 AM
To: AAA Put this in the To box

   I looked up what the chevrolet vega block was made of a few
 daya ago. They used A390 with 17% silicon and etched the cylinder
 bores after honing to expose the silicon as the running surface. It
 is classafied as a high strength alloy. An article on the WIKI site
 was of the opinion that the early problems with the vega resulted
 from an undersized cooling system and oil losses resulting in
 overheating and engine damage. The block was apparently capable  of
 normal overhaul intervals. It seems to be the ideal material for a
 one rotor end housing casting.I ran the same briggs and stratton
 lawnmower for 22 years and 6 sets of wheels on the  same engine, and
 that was an aluminum bore. I retired it when it needed the second
 set of rings and still have it in the shed.This engine was run about
 3000RPM and being air cooled ran hotter than I need in a water
 cooled rotary. It might be interesting to research what alloy nthis
 engine used.

 george grimes

 If it were that easy I think Porsche and BMW would be using it
 instead of Nicasil.

 Paul Lamar


 George,
 It seems to me that the process for machining the Vega and the ZL-1 blocks
was to hone to size. Then they fit the hone with cloth wipers and used a
special compound to lift a bit of aluminium for the surface. This left the
silicone for the rings to ride on. The pistons were tin coated. All was good
until the engine got hot for whatever reason (maintenance?. This then wiped
the tin off and transfered Al between the piston and cylinder walls. Game
over until overhaul. The solution then was to sleeve the block with iron
liners. This may work for aircraft as the rotors are iron. What is wrong
with the RB end housings other than they do not have the wide housing for a
3 or 4 rotor?
Dale Davies

-

You guys, the "Vega" block material was and is used by Porche and Mercedes on their V8 blocks. It worked fine but required carefull set up and the etch step. The reason many went back to Nickasil is twofold. First the nickasil processes improved. Second and I believe the most important, it's cheaper.
Bill Jepson


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.