I am  in  the process of designing and building
mufflers.

There are  two kinds  of course RX8
and 13B.

They will look something like  this and they  will
be built from .065" thick  321  SS.

Cost will be several  hundred dollars.


How many  want RX8 mufflers ?

How many want  13B mufflers?

Paul  Lamar


I need more info, but I probably would want a renesis  (RX8)

Rich

Fire away on the questions and I will tell you what I  know
so far.

Paul Lamar

I will take an RX 8 but want to 'hold  off' on the down pipe
from the muffler until I get my engine mounted at the  front of the 337

Thanks

Clive

No problem.

Paul  Lamar



More questions from the heretic.

1.   Would it be possible to make the headers (from the engine to  the
muffler) longer to clear a possible engine mount conflict?

2.   From the Cad, it seems that there are slip joints  between the headers
and the muffler. Is this correct?

It seems, from my limited knowledge that as the muffler heats up, it will
also expand lengthwise placing  fore-aft stress on each of the three
headers which would encourage cracking. This type of expansion would not be
accounted for by the three slip joints in line with the aforementioned headers.
Any thoughts here?

3.   Have you given any thought, or is it possible, to coat the  inside and
outside of the assembly with "Jet-Hot" coating (outside only  apparently is
not a good idea). According to some (including Tacy), this puts  most of
the heat out of the system, and much less is radiated from the under  cowl
plumbing.

Rich

1. I don't really know. I don't have any 3D's on that mount. I would suggest
contacting the people that built it for help.

2. Yes slip joints every where. Anything is possible but so far nobody
has had problems of that sort with a tangential muffler and many have
flown. They have had problems but not that kind.

3. Sounds OK to me. If it comes off it goes right out the pipe.

Paul Lamar