Subject: Dave Garber's bell 47 PSRU.
From: Rotary Engine
Date: 2/3/2010, 11:25 PM
To: AAA Put this in the To box



Paul,

On your website in the PSRU section you have a picture of Dave Garber's engine mount plate and the sun gear drive plate attached to a object that is obviously bolted to the counter weight.

The object in question is a plate with some sort of cup in the center.  I forgot to ask Dave what that was.    I would guess it was for a bearing. Do you know?

He didn't use any type of torque absorber on the his turbocharged 12A. Did you notice any undue vibrations when you ran it at Sun and Fun?

Doug in Japan

We never let it idle below 2000 RPM.

I think you are talking about these pictures.
The big flaw in Dave's design was not enough spread in the
prop shaft bearings. Those big props would have one heck
of a gyro bending load on the prop shaft. All he had in
there were two closely spaced giant ball bearings.

From the looks of it all the bending load was transfered to
the rear main bearing of the 12A. I would make a 3D of the
whole thing as you have the parts so you have the dimensions.

Paul Lamar




-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.