Paul,
On your website in the PSRU section you have a picture of Dave Garber's
engine mount
plate and the sun gear drive plate attached to a object that is obviously
bolted to the
counter weight.
The object in question is a plate with some sort of cup in the center. I
forgot to ask
Dave what that was. I would guess it was for a bearing. Do you know?
He didn't use any type of torque absorber on the his turbocharged 12A. Did
you notice any
undue vibrations when you ran it at Sun and Fun?
Doug in Japan
We never let it idle below 2000 RPM.
I think you are talking about these pictures.
The big flaw in Dave's design was not enough spread in the
prop shaft bearings. Those big props would have one heck
of a gyro bending load on the prop shaft. All he had in
there were two closely spaced giant ball bearings.
From the looks of it all the bending load was transfered to
the rear main bearing of the 12A. I would make a 3D of the
whole thing as you have the parts so you have the dimensions.
Paul Lamar
Paul;
20years ago I was building a PSRU out of the top 1/2 of a Bell 47
gear box. The project got lost during a messey divorce.
Does Dave Gaeber live in Florida?. I used to know someone in Florida that
was building a twin engine push pull air raceing rotary. He had a landing
gear collaps during taxie tests and I lost contact with him. Would you be so
kind to email me his email address?
Thanks in advance,
Russ Mac Farlane
Yes that was one and the same. Tragically Dave died in a crash last
year. The airplane is still around someplace.
Paul Lamar
--
Paul,
Yes it appears rather short coupled. There are several features in the Bell 47 'as is'
that I don't like. One is using a spine between the planetary mount plate and the outer
bearing. The slop, though minute, pretty much guarentees the need for an inner bearing
like Dave used.
For the purposes of proper alignment only, a transmissions and Mistral's PSRU, both rely
on a simple nose on the end of the drive shaft after the spline to insert into the e-shaft.
Like Mistral I have an intermediate bell housing with a central bearing there to take any
load that it might see from the prop gyroscopic behaviour.
I doubt I'll be doing acrobatics in the SeaWind but it will be experiencing turbulence.
Distance from the PRSU front to back of the prop flange is about an inch. From the front
to the center of the MT prop arc is about six inches
Doug in Japan
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.