Subject: making motor mounts and jigs
From: Rotary Engine
Date: 2/4/2010, 3:07 PM
To: AAA Put this in the To box


 The MM trick is set up a piece of plywood to act as the firewall.
 Prefab the firewall fittings and the rubber holders.
 Locate the rubber holders in space and cut, fit and tack weld
 everything.


 BTW how many people on here can weld steel?

 Paul Lamar


 I do. Are you interested in doing mounts for other people?

 John

 I would be but, 1) I have no credentials as a welder and 2) I'm in
 Canada
 and the border might present some complications. I thought someone was
  doing
 mounts and had jigs and everything ?

 John

 Jerry Hey retired from making mounts due to eye sight problems.
 Me and a lot of other people miss him I am sure.

 Paul Lamar


  Do you have any pic's of Jerry's jig ? I would be interested but I think
 a
  good universal jig would be really important.

  John

  Yes here are some pictures.
  Jerry is pointing to the the prop flange point where he can
  set the off set angle of the engine. Generally my designs incorporate
  an adjustable rear mount so the down thrust angle can be set.

  I'll work on a 3D that incorporate the best of these ideas and
  that can be made mostly out of plywood or particle board.

  The vast majority of the mounts are 39 inches from prop
  flange to vertical firewalls.

  Paul Lamar


 opss

 Here they are.

 Paul Lamar

This certainly looks doable. Is there one particular design that would be
most popular ?

IIRC Jerry found it best if the client sent a ply sheet drilled to match the
individual firewall.
Also you offered tube templates at one time too, would this be helpful or do
you think the jig makes the templates redundant ?

John

The tube templates are a lot of extra work. I would not mind doing
them for something that was very popular but so far every rotary motor
mount seems to be different. People that go for the rotary are
very independent so they don't all build RV's.

You would still need the jig. The best investment is a tube
notcher from Harbor Freight.

http://www.harborfreight.com/cpi/ctaf/Displayitem.taf?itemnumber=42324


The trick is to get free Qcad. I can send 2D dxf's for the motor mount
that will load into Qcad. One can then determine the angles from the Qcad
dwgs and set the notcher angles. Probably not perfect but close
as Qcad is not 3D. It takes a 3D program to do it accurately.

Of course if one has Rhino I can send the 3D dwg and Rhino will
give one the templates and tube notch angles automatically.
Here is an example of the tube notch angle. The trick is to
extend the center line of the firewall fittings.

Several people on here are getting up to speed on Rhino and may
want to take on some of this work. I am not getting any younger :)


Paul Lamar


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.