Paul,
I'm using an RWS EC3, which has a primary and backup manifold pressure
input.
I'm considering using 4 of your oil injector pressure taps, configured as
pairs teed together, one pair for each EC3 input. This would provide
identical, redundant pressure readings. Let me know if you agree & I'll send
you $80 ;/)
--Kenny A.
http://websites.expercraft.com/kennya/
You only need one per RX8 rotor housing Kenny but you can use four if you
wish. All four would have to plug up before your EFI quit working.
Of course it would still not quite quit as the mixture would just
be off.
BTW I up dated the web site in a couple of areas.
One area is how the Wankel works. I added a nice animation.
http://www.rotaryeng.net/how-wank-works.html
The other area is down near the bottom of the front page
where Jeff's motor plate is. I added some info on where
to buy the low cost rubber MM bushings. These are the same
as the Questair Venture uses and they are made by Barry Controls.
The same company that makes $100 aircraft mounts out of
the same material :)
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.