From the Bell 47 PRSU post:
"The motor/alternator of the Belt Alternator Starter
(BAS) hybrid system is driven by a high tension belt
from the engine crankshaft. It boosts power under
acceleration, charges the battery, and restarts the
engine after AUTO STOP."
"The GM Belt Alternator Starter (BAS) requires 36 volts to run. What you
would save on starter weight, you lose on having to carry two extra
batteries. "
"That certainly is a drawback for most of us."
I would suggest that the "BAS" probably needs some type of a regulator to
charge 36V batteries. It should be possible to modify it to charge at 28V.
Also, I doubt that a rotary engine would need the same high current starting
capability as an instant start auto engine. If it became a real need to
adapt a
BAS I'd probably have a deep discussion with my local rewind shop.
Fred O.
Fred,
I had this discussion with Mistral years ago in an attempt to put a specially wound
starter/alternator inside their bell housing. At that time with a 24vdc input, the
require amperage to start the engine would be well over 200 amps.
Now we are talking about pancake permanent magnet motors here, and there is some hope in
the near future that this approach will pay off.
Look at what Honda has done with a small scooter recently. Scaling it up to work with
the rotary engine would be a project worthy of say Mazda. Instead they use a starter
motor to position the engine correctly and then squirt in and ignite fuel to start their
engines.
Doug in Japan
What ever you attached does not work Doug. What was it?
Was it a web site address? Make sure what every you attach has an
extension after the dot. Such as: jpg, pdf, doc, gif, xls, zip, etc., etc..
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.