Subject: comparison to a turbine
From: Rotary Engine
Date: 2/12/2010, 2:33 PM
To: AAA Put this in the To box

It looks like mistral has a very good shot at successful entry into the
aviation field.
Look at the specs of this latest Rolls-Royce entry.

http://www.rolls-royce.com/defence/products/helicopters/rr_300.jsp

A P-Ported turbo compound (with LW end and center plates) would beat this
hands down, for
installed weight, fuel consumption, power to weight, and probably intitial
cost if the
turbo compound existed. Even with out the TC, the numbers are very close. So
where are the
investors? If RR can justify this entry, one would think the rotary TC could
be developed
for less than half the cost of a turbine.
C. Smith


I'll say. A Mazda two rotor p-port powered helicopter would have almost
twice the range. In other words half the fuel burn. This is a no brainer.

Apparently there are no entrepreneurs left in Europe :)

Paul Lamar

Two different (while slightly overlapping) markets. In the private and
experimental market where planes (and heli's) barely chalk-up any
hours, all the talk is about fuel burn and acquisition cost. Whence
you dive into the commercial spectrum, TBO, overhaul costs, parts
availability, etc. come into play.

Is the Mistral engine PP and use Al plates? Last I checked (and it has
been a while) they were side port and Fe. I'm not saying that Mistral
isn't going to be successful, but I don't predict any ripples in the
commercial area.

Regarding entrepreneurs, there be plenty. Now investors..... that's
another story.

Vlad

It has been reported on Speed TV during the 2010 Daytona RX8 win that the
cost of overhauling a 3 rotor is only $8000. Try $100,000 for a
competitive racing piston engine and a lot more than that for a turbine.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.