Subject: Thrust plate Bolts and tension bolts
From: Rotary Engine
Date: 2/15/2010, 11:23 PM
To: AAA Put this in the To box

snips...

Once you have the correct end play, remove everything down to the thrust
plate and bolt the plate down with all of the bolts. Safety wire the bolts
with the finished ends inboard to avoid the counerweight touching them. No lock
washers. Those thing only bit into the shitty bolt heads and make swarf to
fall of into the bearings. Use hard washers the same thickness.

The bolts are crap, but that is fine. the threads in the casting are weak.
No locktite as the threads may come out with the bolt, or the bolt may break
off. Just to minimum torque and wire them.

Lynn E. Hanover


Lynn,
I replaced all of the bolts with new and had planned on using split lock
washers since that's what was there originally. Also there was no safety
wire. I'll get some bolts with holes in the heads and new flat washers. I
presume it'd be a good idea to do the same with the rear stationary gear?


Jay

Thats just me, but a lock washer cuts into the bolt head and leaves behind
a bit of swarf.
There is just no need for lock washers from the 1870s inside an aircraft
engine. A hardened flat washer gives up no metal. The bolts are too short to
develop any tensile clamping force in the normal sense. Just torque to the
minimum spec and wire them just like an airplane engine.

Case bolts:

If it was my engine, I would do the spiral of silicone (100% GE tub and
tile caulk) and around the shoulder of the bolt for about 2" a solid slug of
silicone.

Then under the longer than stock rear stationary gear bolts a big .032"
plate then the hard washers then torque and safety the bolts. The sheet metal
disc prevents a broken bolt head from wandering out of the block and getting
tangled up in the flexplate or flywheel.

With the silicone on the bolt shoulder, it won't even loose coolant. One of
the RX-8s had to drop out of the 24 hour race because they broke a case
bolt and were loosing coolant.

Had they done the silicone and flat plate trick they would not have lost
anything. There is another trick you don't want to hear about. If you chamfer
each case bolt hole in each face of each iron and rotor housing, and on
assembly put a little ring of silicone around the chamfer, when the stack is
torqued up little silicone "O" rings form up between elements and clamp onto
the case bolts, sealing between elements the case bolt cannot sing and break.
But if it does break, nothing can leak between the segments, Coolant
dripping into the oil would be the big problem, but that cannot happen now. Again,
it makes a big mess and looks unprofessional, but once its all buttoned up
and painted just you know about it.

The plate needs only be big enough to cover half of each bolt head.
Rookies........

You might have to use a slide hammer to remove the bolts 2,000 hours from
now, and it makes a big mess, but so what?

Lynn E. Hanover


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.