As usual, great post. With the risk of sounding anal couldn't I just use
the end mill to
create say
a 0.8 mm step within each hole and slip a 2mm cross sectional O-ring on the
through bolts?
No vibration, and easy to rebuild if necessary. My rotary engine is
probably going to
grab the world
record number of O-rings as it is. Love em. Properly used they don't leak.
Doug in Japan
That might be a good looking option. The "O" ring need not fit tightly
against the bolt to seal well enough. It would take a bit of experimentation to
get the combined depth and width for the grooves, in order to get a seal but
still be able to push the bolts in without disloging a ring and then need
to fish it out and go without a ring in that position, or pull the stack down
and start over again. The irons need to be nearly tight in order to keep
the corner pieces (if any) from popping out of the grooves. But a happy medium
may be in there somewhere.
A bit of a countersink in the rear iron below the bolt heads would allow
room for a couple of thin "O" rings on the bolt shoulder to seal up the last
iron as well.
Lynn E. Hanover
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.