Paul suggests to source them from Mcmasters, but there are about 20
to pick from. Can you narrow the gap ??
Thanks, Neil Unger.
Hey guys please don't attach emails as it makes a mess. Forward
quote only. Not a bad idea but for consistency we have been doing it
this way for 11 years.
The one listed on the web site is the correct one.
The load per mount is 240/90 and the McMaster part number is 6309K3
price is $5.95 cents US as listed on the web site. See the
attached jpg. When ordering you must specify the load and the durometer.
The E dimension is the critical number which is the bolt hole
size and that is .53 inch. McMaster was trying to save catalog
space but it added a lot of confusion.
What I did was eliminate all the irrelevant part numbers from
the jpg on the web site. McMaster does not list them by manufactures
part number. It is rather confusing. Here is too the Barry catalog
page.
Here too is a dwg on the mount holders/welding cups. We are making
up a low cost batch of these for sale for as we speak.
Note the .5 inch hole for the bolt.
Sorry about the confusion.
Jeff,
Better save this email as the subject will come up in the
future when people order plates from you.
Also read:
http://www.rotaryeng.net/dyno-mot-mount.jpg
I need to upgrade this as there is an error or two.
The main one is it is prop torque and not engine torque.
You might want to offer this as an option. You get an
in the air read out of the Torque the prop is making so
you can calc the HP knowing the prop RPM.
This about the same as the torque meter device that comes with
the P&W PT6.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.