Subject: CS Prop And Prop Drive Disconnect for Rotary
OK here is a new thread.
I am replacing the engines on my Cessna 337 one at a time. Front one first
(to work out
all the problems) then the back one last. I am using the 3 rotor turbo
engine for both
(obviously).
Because of emergency single operation proceedures I need a PSRU made that
will also drive
a CS Propeller Governor (like the Mistral PSRU) and I would like to
incorporate a
Propeller disconnect feature as well, i.e. use the standard torque convertor
or manual
clutch assembly with bell housing and bolt on the PSRU where the gearbox
would usually go.
Suggestions please??????????
Clive in FL
The best thing I can say is build your own unless you can talk Mistral into
selling a couple of theirs. You might be able to start with a couple of junk
Lycoming cases. There should be plenty of those around unless they have been
melted for scrap.
Mark Steitle
runs an electric MT on his 3 rotor Lancair ES. They have a sales office in
Deltona as I recall.
Paul Lamar
Clive,
You may want to consider this unit.....I've spoken with Bud about adapting
(parts of) his unit to rotary engines (still using the planetary gear
arrangement and getting away from his offset geared drive, but he thinks the
planetary is not suitable for such use--???).....perhaps you could convince
him it needs to be done! (or use the Subaru unit with an adaptor) He does
now offer a "no offset" gear drive.....up to 250 hp, I think.
http://www.geareddrives.com/ They have some interesting videos of their
machining processes.
http://www.geareddrives.com/PSRU_Eggenfellner_Subaru.html
This unit is freewheeling at start up, the clutch pawls engage by
centrifugal force, and it is a standard hydraulic constant speed unit with
take off for the governor; you could use ANY standard CS propeller (even
your current Continental fitted units maybe). No load on the starter.....but
they ain't cheap......but they have their own oil pump and filtration
systems.....lots of good features.....not to many in the field, so wear and
durability may yet to be proven overall.....I think if one of your engines
dies the prop goes to idle (airspeed) flow, unless your governor has an
accumulator and can feather and un-feather it?
Let us know how you make out.....I would sure be interested, as I'm sure
MANY of us would be!
Marc Wiese
Marc Wiese.
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.