No way would that muffler you are building fit in my cowl. Nor would the
slide throttle PP engine from your video. One of the things that sold me on
going the rotary route in the first place was the compact size. I'd love to
duplicate the 4 port intake on the BEC engine (minus the Airflow Perf
injection - I'd stick with electronic injection). A PP design that hugged
the engine like the BEC intake would be best of both worlds.
Mike Wills
I tried it on tubing and it worked but you have a good point there.
I stand corrected on surfaces. Of course the glue will melt.
Looks like one would need a layer of fiberfrax with a .010" thin
sheet of SS mechanically fastened to the
fiberglass with SS screws or monel pop rivets.
Another alternative is put some $10 Home Depot steel wall heating
register near the exhaust pipes. That will let out some of the heat.
Here is a typical register. You can throw away what you don't need.
If it melts the paint you could get it chrome plated.
McMaster Carr has micro perforated 316 SS sheet 35 gage
which is .0075" thick with a bunch of tiny .009" dia.
holes that will let out the heat. Rather expensive
at $170 for 22 by 24 inch sheet. However this is
an elegant solution to a skinny cowl :)
They also have 304 SS .024" thick with .062" dia. holes for
about $68 for a 36" by 40" sheet. 39% open area.
This appears to be the best bet.
If you make a custom slide it will fit. The trick
is to weld the runners directly to the outer cover.
Like we did on Mark Supinski Mustang.
Here are some 3Ds.
That muffler won't fit but a 4.5 inch diameter tang muffer
might.
--------------------------------------------------
Here is a second way Mike.
Can anybody come up with a third way with equal length
22" runners? Must be a 3D rendering :)
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.