Subject: Mike Wills P-port in RV4
From: Rotary Engine
Date: 2/22/2010, 8:43 AM
To: AAA Put this in the To box


 No way would that muffler you are building fit in my cowl. Nor would the
 slide throttle PP engine from your video. One of the things that sold
 me on
 going the rotary route in the first place was the compact size. I'd
 love to
 duplicate the 4 port intake on the BEC engine (minus the Airflow Perf
 injection - I'd stick with electronic injection). A PP design that hugged
 the engine like the BEC intake would be best of both worlds.

 Mike Wills

 I tried it on tubing and it worked but you have a good point there.
 I stand corrected on surfaces. Of course the glue will melt.

 Looks like one would need a layer of fiberfrax with a .010" thin
 sheet of SS mechanically fastened to the
 fiberglass with SS screws or monel pop rivets.

 Another alternative is put some $10 Home Depot steel wall heating
 register near the exhaust pipes. That will let out some of the heat.
 Here is a typical register. You can throw away what you don't need.
 If it melts the paint you could get it chrome plated.

 McMaster Carr has micro perforated 316 SS sheet 35 gage
 which is .0075" thick with a bunch of tiny .009" dia.
 holes that will let out the heat. Rather expensive
 at $170 for 22 by 24 inch sheet. However this is
 an elegant solution to a skinny cowl :)

 They also have 304 SS .024" thick with .062" dia. holes for
 about $68 for a 36" by 40" sheet. 39% open area.
 This appears to be the best bet.

 If you make a custom slide it will fit. The trick
 is to weld the runners directly to the outer cover.
 Like we did on Mark Supinski Mustang.
 Here are some 3Ds.


 That muffler won't fit but a 4.5 inch diameter tang muffer
 might.

 --------------------------------------------------

 Here is a second way Mike.
 Can anybody come up with a third way with equal length
 22" runners? Must be a 3D rendering :)

 Paul Lamar

Paul

Can you send me some kind of solid of the entire engine block, I can
work up some ideas.............I plan to P-port the BEC but wrap it like
it is now..........

jeff

Sure this is very basic but it is small. Been around for 11 years.
Let me know if it does not work as I have dozens of others.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.