Subject: Rhino - not feeling the love
From: Rotary Engine
Date: 2/22/2010, 7:47 PM
To: AAA Put this in the To box


 Hi Paul-

 Trying to do some simple modeling with Rhino.  I'm not loving it.
 Stuck trying to do something very simple.

 I just want a triangular solid.  (imagine a 1/8" thick sheet of al.  I
 want a right triangle 19" x 4".)

 Hints on how to do it?

 Mark Supinski


 Go into dimension properties grid set snap spacing to .125

 In the side view draw two perpendicular lines one 19" and one 4".
 Select loft under surface. Chose the lines and press enter.
 Viola you have a surface. Go into the top or front view
 and choose solid-extrude surface-straight.
 extrude it .125 inches. Your done.

 Paul Lamar

 Mark,

To get the two perpendicular lines, right click on the line icon
near top of left side toolbar, click a point on the screen then use relative
coordinates in this case r19,0,0 and then r0,4,0 to get the lines.

If the triangle isn't lined up with the grid draw a line longer
than 19 (like 24") then pick a point more than 4" away from one ot the
ends and click the perpendicular snap  on the bottom toolbar to get the 90
degree corner. Then  go to curve/offset curve and offset the short line 19"
and the long line by 4" to make a rectangle draw a line from corner to
corner with the intersection snap and trim off all the unwanted stuff (trim
is near the bottom of the left toolbar). You can join lines with the
edit/join command and then surface /planar curve to get the surface.  solid/
extrude surface/ straight with a .125 distance to make the thickness.To get
rid of whole lines just select one and push the delete key.

Don't be confused by Rhino considering all curved and straight
lines, circles etc to be classified a "curve".
You can download the user guide as well as two large manuals from the wiki/
McNeel web site. They are fast to read and show where to find the commands
on the screen.The book "working with Rhino 4.0" from  novedge.com
 (santa Paula calif) is a good book also but not free ($35)

george grimes

ROFL

Paul Lamar



Technically, a line is a curve..  A line is a curve with an infinite radius.


Matt-


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.