Hello Paul and all rotary people:) I´m  Michael and I ´m from Slovakia. I´m
19 and I have started building my first rotary engine -RX 8 p-port with
slide throttle. Here are some photos. What are your opinions about my work?
I will send you a graph of the power of this engine with very short length of
intake.

Michael


http://www.eset.sk

You got a bit of splatter on the weld Michael.
If you sand it down it won't hurt the power much as the pressure
drop across the apex seal is near zero in that area.
However It might affect the wear on the apex seal so
you should start over with another rotor housing.

I would very much like to see the power chart with that
length of intake.

Paul Lamar