Subject: Aircraft braking systems & staic thrust
From: Rotary Engine
Date: 3/2/2010, 1:13 PM
To: AAA Put this in the To box



   Wow! Here is a physics question for everybody. How much
   net out of the prop HP is Mark's engine generating? Assume
   the coefficient of friction between tire and pavement is one.

   Paul Lamar

Somewhere in the past, in what seems like an earllier life, I earned a
master's degree in classical physics. And I wouldn't touch the above problem
with a 10-foot pole, if I had to swear to the accuracy of the answer. Far too
many assumptions/variables involved in the problem to make an answer
defensible.

On the other hand, Bob Barrows, designer of Bearhawk aircraft, did some
practical measurements of static thrust produced by various engine/prop
combinations on his Bearhawk aircraft using a thrust-meter of Bob's design.
He published the results on page 16 of his 2004 Bearhawk Patrol Newsletter.

The following are figures from that newsletter.

Bearhawk......    O-360@170HP ...    CS Prop .......    750# thrust
PA 20/22 .....    O-320@160HP ...    73/57 Prop ....    540# thrust
Super Scout...     O-360@180HP ...    84/56 Prop ....    740# thrust
C-172 (1971)..     O-32o@150HP ...    75/60 Prop ....    525# thrust

For a complete report or further information on testing procedures one might
contact Bob Barrows, R&B Aircraft, 540-473-3661

Robin Berglund

Bingo sort of. It is a trick question. You cannot determine the net HP out
of the prop regardless if you can calculate the thrust or not. You can calculate
the thrust if you have the weight on the tires and coef. of friction between
tires and pavement and the tires are sliding.

HP is a force moving at a speed. The A/C speed here is zero so the net HP out
of the prop is zero as far as the A/C is concerned. The HP going into the prop
is another question. That HP is being used to accelerate a mass of air and heat
the air stream. I suppose if you knew the mass of the air affected and the temp.
increase you would know the HP.

Bob Barrows is one of my favorite people. I always make a point of looking him
up at air shows. He usually hangs out around his airplane.

Lets get down to something doable.

What is the easiest way of measuring that HP?

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.