Clive Ure wrote:
Paul,
Are there any types of 20B engine that are 'lemons' that
I should not consider for my 337 project. Any years better than others?
Regards
Clive
Not that I know of. The only rotary engine I know that might be labeled a lemon
was the 2004-2006 RX8 engine and it had nothing to do with the engine
it self. Mazda merely cut back too far on the apex seal oil supply.
Fixed around 2007 with three instead of two oil injectors per rotor. Of course
we mix 2 cycle oil in the fuel to bypass that situation.
The 1989-1990 initial Turbo II engine cracked the exhaust manifold with
regularity. Fixed more or less in the 1991-1992 Turbo II engines.
A lot of Turbo 3rd gen guys blew them up by boosting the engine without
adjusting the fuel supply. They ran lean. The 3 piece apex seal
design did not help. Done away with in the RX8 engine with a 2
piece design now retrofitted to all engines.
Paul Lamar
Thanks Paul,
1.Shall I use the existing turbo(s), I want to turbo normalize so I want to modify the
waste gate to manual operation controlled by the pilot.
2.I would like to use the existing injectors? and the computer to control them or do you
suggest something else?
3.I like the slide throttle concept like the one attached here, is there anyone who can
make one for me?
I have read Tracy's book and your 'cooling' book.
I really value your opinion.
Thanks
Clive
You might have trouble with the stock turbo's. They are not
up to continuous high power. Especially at 12K and above where
the back pressure is down. They tend to over rev and the turbines
blow. At least that happened on the turbo 2 rotors.
I would change them out for one AC turbo.
Tome Parkes on here has a 3 rotor with an AC turbo in a Lancair ES.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.