Subject: Wanted to buy 13b parts
From: Rotary Engine
Date: 3/3/2010, 2:12 PM
To: AAA Put this in the To box


 Looking for flex plate, counter weight and a front cover  that supports a
 tooth wheel instead of a CAS.  Thanks for any  help

 Joe Berki
 13b 2nd gen

 Joe,

 You can buy a front cover for an rx7 FD off of  Ebay.  I bought a cover,
 but I haven't been able to find the pick up  modules or toothed ring.  I
 may
 end up just keeping my original CAS because  I don't really understand how
 to
 convert into the other system and run Tracy's  EC3 with it (although Tracy
 said it will work fine).  I  think I will have to make a custom toothed
 wheel for my 20B anyway and then try  to figure out how to mount multiple
 CAS
 modules at proper locations around the  toothed wheel......but I haven't
 really jumped into it much yet.  I need a  good "20B Aircraft Conversion
 for
 Dummy's" book !!!

 Don



Don,

I converted my 20B to the new crank mounted CAS by using a Renesis toothed
wheel.  I had to purchase the entire front pulley assembly (purchased from
Mears Mazda) but only used the toothed wheel.  I made a bracket to locate
the CAS sensor to the 20B front cover in the same position as on the
Renesis.  *Note:* *This bracket must be fabricated from non-ferrous
material.*  Then you need to send your EC-2 back to Tracy for modification
to the Renesis style sensor.

I also had to add a zener diode/resistor circuit in order to limit the CAS
output voltage.  This was determined by the use of an oscilloscope and
trial-and-error.

Looking back on the experience, It wasn't worth the effort.

Mark

BTW Mark order some of these O-rings to save time for your sealing
blocks. I had an order in but it got lost.

Paul Lamar



Will do...

Thanks,
Mark


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.