Subject: Aircraft braking systems & staic thrust Wood bar method link
From: Rotary Engine
Date: 3/4/2010, 11:53 AM
To: AAA Put this in the To box


 What is the easiest way of measuring that HP?


 Obviously the horspower is being transferred to the
 air, not the aircraft,
 We
 can measure thrust on the aircraft, which relates
 directly to HP.  We can
 measure the kinetic energy of the air, which relates
 directly to HP, There
 are quite a few indirect means available to us.

 I am reminded of a story/joke I once read a really
 long time ago (I think
 I
 was in high school). It has to do with how one might
 use physics to answer
 a
 question. I typed the story out as I remember it. It
 got quite long, too
 long
 to clutter you your email inboxes.  But if you
 want to read a little (very
 little) physics humor, you can check it out.  I
 posted it at

 http://poplar.us/TallBuildingQuiz.doc

 Robin
 Have been following the chat with interest. What if you go
 back to tying
 airplane to the tree and adding a load senser to the mix
 like they have on
 cranes, then you would have a reading in lbs. Any changes
 you do to the
 engine could be measured similar to dyno testing if your
 really poor like
 most of us

 Wally in Canada

 Static thrust is not the whole story. What you are mainly
 interested
 in is HP in the climb mode and low fuel burn for cruise or
 MPG.

 Paul Lamar

 -

 Opps sent without the last bit
 WOOD BAR DYNO exl allows you to generate hp and torque
 curves

 The first link takes you straight to the downloadable link
 and the second
 one takes you to the forum.  With pics and
 explanations.

 Simple yes... not for you Ok .  Its free......

 Clive...................England



I believe "KitPlanes" had an article on building a thrust guage on the cheap, it consisted of a hydraulic ram that you drill and tap for a cheap pressure guage, then by hanging known weights you calibrate the pressure scale into thrust. With a strong cable, attach one end to a car the other to your aircraft, fire up and see what you get. They listed the parts as around $60, and other members of an EAA chapter would also use it for their home built AC.

Dave James

Garage door spring.

http://www.rotaryeng.net/art-lst6.txt

How to Weigh Your Engine by Paul Lamar
Kitplanes
February 1998 page 26
Build this low cost scale to verify powerplant weight.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.