Subject: EFI-mp pressure sensor Att.Mr. Lazik
From: Rotary Engine
Date: 3/4/2010, 6:27 PM
To: AAA Put this in the To box


Paul,
Where is the development for the simple EFI at?  I am currently set up with
a Ford MAF but the latest is that they ar non-linear.  So I find the
algorithim then build a signal conditioner to accomplish linearization. Yea,
right.  The last thing I remember is the group was discussing going after a
DOS approach to the injection thing.  Appreciate any input. Joe berki Limo
EZ


Don't use the Ford MAF. It is indeed non linear. Just use the same $10 Free
Scale manifold pressure sensor part Tracy is using. Everything will work
fine. Especially since we discovered a problem with where people were
attaching the pressure sensor. In other words all over the place. The best
and most stable place to measure the manifold pressure is the oil injector
hole. Particularly with a slide throttle and a P-port.

You can probably sell the Ford MAF on ebay.

Paul Lamar
-- 
That looks like the STC'd mp sensor JPI uses in the EDM 800/930 series of
engine monitors. I hooked one up to the mp gauge on my neighbors Cessna..to
the monitor/calculate hp and display mp (corrected)....(and lots of other
sensors, too).....

Marc Wiese

They are very popular as they are very simple to use and cheap.
Most sensors put out low level signals and it is usually necessary
to amplify the signal before recording it. These sensor have the
amplifier built in and they put out an industry standard data
acquisition signal of zero to five volts.

The speed of response is about 1000 samples per second so we used
two to record the pressure waves in a tuned p-port manifold.
Here is some of the data.

They are a real bargain at $10 each from DigiKey.

Paul Lamar

-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.