In order of when received.
Please vote on your favorite.
The first 3 were done with Solid Works.
Jeff, Jarrett and Larry.
The next one was done by George with Rhino.
George did a remarkable job based on only
three weeks of learning.
I took George's design and used Rhino
to make a few improvements like radius the
cooling openings for the last entry.
IMHO the point is that the $4000 cost of Solid Works
is hardly justified compared to the $1000 cost
of Rhino. They both do simple things like
mechanical parts with about the some quality.
Solid works has a slight advantage for mechanical
parts.
IMHO Rhino is clearly a better tool for cowlings.
Paul Lamar
--
All of these look great, I'd be happy to have any of them on the front of my plane (if I
had one :( )
- Part of the choice boils down to what a user wants--something that looks
"conventional" even though we don't have a horizontally opposed engine under there, or
something that looks good and also fits the actual cooling requirements of our installation.
I vote for Larry's design, with Jeff's as a close second.
If I had any talent and any skill with Rhino, I'd draw a wide, thin profile design like
Larry's, but with no intakes at the front, and put a wide scoop underneath to feed a
low-mounted horizontal radiator.
Again, all are great. Thanks to all for contributing.
Mark W.
There are lots of improvements that could be done over the existing 'stock' cowl..
As I understood it, when the challenge was given. We were to try and duplicate
the original as close as was possible. [Duplicate what we saw in the pictures].
If I was to design a cowl for a Rotary install, it would look significantly different from the
stock unit.
Jarrett [I won't vote... since I entered :) ]
You are correct Jarrett it was not a design contest per se.
It was a attempt to duplicate the stock cowl.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.