Subject: building cowl molds from step files
From: Rotary Engine
Date: 3/6/2010, 2:45 PM
To: AAA Put this in the To box



 After you have designed your cowl using a 3D program
 how do you go about building it?

Paul Lamar

I load it into my CAM program... after a hr or so of work I take a USB
chip out to the shop. Load it into my machine.. hit "Cycle Start" and
magically... several hrs later there is a cowl there :)..

Ok so there are some additional steps in assembling a foam block
and what not but thats the basics.

I've got a foam block going on it today that is 30" wide x 90"
long and ~30" deep..

will soon be a Cargo Pod mold/buck for a Super Cub.

Jarrett

We should all be so lucky :)

Paul Lamar

I don't do just my own projects on it.. it's there to help others.. :) I've got a website
[still needs to be updated] but shows some of the nesc details.
www.innovention-tech.com
Jarrett
What would you charge for an RV10 cowl buck?
Paul Lamar

Are we talking a one off foam buck over which the fibreglass would be laid up or a
full buck ready to pull a production mold?

Jarrett

What is the difference? Is it surface finish?

Paul Lamar

Why not print the out side of the cowl surface as a (negative) template, to make a direct lay-up mold??

Keith Moore

That can be done but it is rather hard to smooth and sand the convex surface.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.