Paul
I plan on running my Cozy with a 20b rotary. I would like to run without
the oil injection system. Once the pump has been removed is there any
part
inside the motor I should be removing? Also how do I cap off the oil
injection ports. I checked your rotary website and couldn't find anything
on this.
I also 1/4" aluminum water-cut plates to cover the where the injection
pump
normally mounts if anyone wants to buy them.
Rick Irwin
www.iconixresearch.com/aircraft (20b cozy site)
There is a shaft driving the pump that will still be in there
but your flat plate covers the spot where the pump is. You can put short
ten mm bolts in the oil injector holes, use my pressure taps
or drill out the stock injectors and use some blank off sleeves
to seal the rest of the injector holes.
Paul Lamar
Thanks very much for the input.
Rick
I'll buy some of those plates from you and sell them on here
Rick if you wish.
Paul Lamar
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.