Subject: question on removing oil injection system.
From: Rotary Engine
Date: 3/6/2010, 5:58 PM
To: AAA Put this in the To box


 Paul

 I plan on running my Cozy with a 20b rotary.  I would like to run without
 the oil injection system.  Once the pump has been removed is there any
 part
 inside the motor I should be removing?  Also how do I cap off the oil
 injection ports.  I checked your rotary website and couldn't find anything
 on this.

 I also 1/4" aluminum water-cut plates to cover the where the injection
 pump
 normally mounts if anyone wants to buy them.

 Rick Irwin
 www.iconixresearch.com/aircraft (20b cozy site)

 There is a shaft driving the pump that will still be in there
 but your flat plate covers the spot where the pump is. You can put short
 ten mm bolts in the oil injector holes, use my pressure taps
 or drill out the stock injectors and use some blank off sleeves
 to seal the rest of the injector holes.

 Paul Lamar



Bruce Turrentine recommended using 4130 steel to cover the oil inj. port,
because the shaft will rotate against it.
Bill Schertz
KIS Cruiser #4045
N343BS
Phase I testing

If that is the case it it best to take it out of the there but be
careful putting the front cover back on. It is best to do that with
the e-shaft vertical so the thrust needle bearings can go back in
the right way. I.E. concentric.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.