Subject: building cowl molds from step files
From: Rotary Engine
Date: 3/7/2010, 11:42 AM
To: AAA Put this in the To box



Paul for  a two pc buck [top and bottom] w/ flanges and mold lines finished
and ready to
wax and pull a production mold your looking at $3-4000. Provided the
supplied model is
comlete to the degree needed and depending on details on  the air intake
areas etc. Now
that may sound like alot but from that part  you'd be able to pull many
multiples to
ammortize the initial  cost.

A 'lost foam' block buck would be less than $1000 [as low as $500
depending on features etc]

All of these bucks would need to be done in  multiple parts and then
assembled and finished
as a final buck. I'm not  able to reach the needed 4ft in depth to machine
these in one
part. Once I  get the 5 axis head working.. it would then be easier to do
them in one
setup, which would make them somewhat cheaper. Assembling multiple bucks
to create one
major assembly sounds harder than it is, as the mating parts  of the bucks
can be drilled
and self jigging for final  assembly.

Fwiw

Jarrett

Does not sound like the economics  are there yet. Best to make do
with the stock cowls.


Paul  Lamar
-- 


Paul and Jarrett good subject.
Jerrett, do you think you could do two female halves, (top and bottom), if
the inlet wasn't complicated?
Bill Jepson


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.