Subject: building cowl molds from step files
From: Rotary Engine
Date: 3/7/2010, 11:34 PM
To: AAA Put this in the To box


Paul for  a two pc buck [top and bottom] w/ flanges and mold lines
finishedand ready to
wax and pull a production mold your looking at $3-4000. Provided the
supplied model is
comlete to the degree needed and depending on details on  the air
intakeareas etc. Now
that may sound like alot but from that part  you'd be able to pull
manymultiples to
ammortize the initial  cost.

A 'lost foam' block buck would be less than $1000 [as low as $500
depending on features etc]

All of these bucks would need to be done in  multiple parts and then
assembled and finished
as a final buck. I'm not  able to reach the needed 4ft in depth to
machinethese in one
part. Once I  get the 5 axis head working.. it would then be
easier to do
them in one
setup, which would make them somewhat cheaper. Assembling multiple
bucksto create one
major assembly sounds harder than it is, as the mating parts  of
the bucks
can be drilled
and self jigging for final  assembly.

Fwiw

Jarrett

Does not sound like the economics  are there yet. Best to make do
with the stock cowls.


Paul  Lamar
--


Paul and Jarrett good subject.
Jerrett, do you think you could do two female halves, (top and
bottom), if
the inlet wasn't complicated?
Bill Jepson

Hey Bill, long time no chat.  Yes there are several ways to break a major
part down to reasonable size parts. In the case of yours I think I'd split it
about 1/2 way back from the spinner end and machine that as 1 part and
the rear 1/2 as the second. These could have a plywood spines which are
also 'splitable' to get two halves that way as well. Having it sitting on
the 'firewall' end while machining it means we can get all the intake and
ducting stuff right in there from the get go.  The fit up of the front and back
sections can also be 'jigged' so it is pretty much a seamless joint.

The world record setting kayak I helped w/ was split up this way... they
put it back together and went on to set a world record so.. it works :)

Jarrett


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.