Subject: Water pump inlet outlet conficts with slide throttle
From: Rotary Engine
Date: 3/12/2010, 11:49 PM
To: AAA Put this in the To box


Jeff built something that solves this proplem.
It is a block with a filler pressure cap on top.
It is designed to be compatible with the p-port
slide throttle RX8 engine or RX8 front cover water pump.

There is enough meat on it so pressure and temperature
sensors can be adapted. You could have two temperature
sensors. One for water temp into the pump and another
for water temp out of the block.

There is also meat enough for a vent line return
to a point just under the pressure cap.
All you do is drill the right size holes
and tap for pipe threads.

It is set up for two 1.5 inch 90 degree bends
so it is a better shot to a rad located either
under the engine or on the cool spark plug side.
These bends can be bonded to  the block with
JB Weld or Devcon if you want to go high
buck. They can also be rotated to point
in the proper direction. The 1.5 inch OD bends are
available from Burns Sainless and you
will need a beading tool or wiggins couplings.

The JB Weld worked fine on the wiggins
coupling we built a few years ago. You must
however prep the aluminum before attempting to bond it.

A set screw can be used for a belt and suspenders
approach.

I'll be doing a better 3D shortly.

Paul Lamar
-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.