Since i joined the group i know several of you are doing
some tig welding and i need some advise and comments
to find the cheapest unit and the appropriate one for
my project,i will have to weld my drive housing with
reinforcement gusset of 1/4 " thickness aluminum plate
and to 1/2 plate i found lot on the market true EBAY
and CraigLists.com.
I handle pretty good the acetylene torch , have
welded 2 chromemoly tubing Dafhne frames and with
a few practice i am convince i will be fine to
handle the tig welding.
As per some expert they say i will need minimum
250 amps for the 1/2" plate
Jean Prudhomme
Jean,
You do not want the cheapest welder you can find, especially to weld Al.
The low cost ones usually only have a 20% duty cycle. That means only 12
minutes per hour. To weld the 1/2" Al., I would look for a unit that gives
40 to 50% duty cycle. Cost likely $3000 and up a bit.
Dale Davies
Jean,
1/2" aluminum plate is the tough part. I have a Miller Syncrowave 250 that
would do it but it cost 3K+ when I bought it. If cost is your biggest
sticking point I would suggest looking into one of the inverter technology
welders from Miller or Lincoln. When looking be sure to mention the need to
weld
1/2" aluminum plate which may be too tough for them. You will need a water
cooled torch I'm sure. That isn't something that comes with the inverter
style welders from either manufacturer I believe. The Syncrowave products
are often sold in package deals which can often be negotiated on price.
That
may be your best bet, but don't think anything with the capability to weld
thick aluminum will be cheap. Note also that you will need at least a 50
amp 220 service in your shop.
Bill Jepson
This is the machine I bought.
http://www.htpweld.com/products/tig_welders/tig201.html
It will do almost everything the miller dynasty can do.
Can be gas or liquid cooled, price for package includes the torch and foot
pedal. All in all about $800 to $1200 less than a miller Dynasty when you
include the torches.
Jeff Noland is the owner, and he threw in some extra stuff for free when I
bought my 70201-WC setup.
Only needs a 30 amp service to get a full 200 amps of welding power.
C. Smith
--
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site.
http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.