Subject: Need your advise to purchase a tig welder
From: Rotary Engine
Date: 3/13/2010, 6:51 PM
To: AAA Put this in the To box


Since i joined the group i know several of you are doing
some tig  welding and i need some advise and comments
to find the cheapest  unit and the appropriate one for
my project,i will have to weld my  drive housing with
reinforcement gusset of 1/4 " thickness aluminum  plate
and to 1/2 plate i found lot on the market true EBAY
and CraigLists.com.

I handle pretty good the acetylene torch ,  have
welded 2 chromemoly tubing  Dafhne frames and  with
a few practice i am convince i will be fine to
handle  the tig welding.

As per some expert they say i will need  minimum
250 amps for the 1/2" plate

Jean  Prudhomme


Jean,
You do not want the cheapest  welder you can find, especially to weld Al.
The low cost ones  usually only have a 20% duty cycle. That means only 12
minutes per hour. To  weld the 1/2" Al., I would look for a unit that gives
40 to 50% duty  cycle. Cost likely $3000 and up a bit.

Dale  Davies


Jean,
1/2" aluminum plate is the tough part. I have a Miller Syncrowave 250 that
would do it but it cost 3K+ when I bought it. If cost is your biggest
sticking  point I would suggest looking into one of the inverter technology
welders from  Miller or Lincoln. When looking be sure to mention the need to weld
1/2"  aluminum plate which may be too tough for them. You will need a water
cooled  torch I'm sure. That isn't something that comes with the inverter
style welders  from either manufacturer I believe. The Syncrowave products
are often sold in  package deals which can often be negotiated on price. That
may be your best bet,  but don't think anything with the capability to weld
thick aluminum will be  cheap. Note also that you will need at least a 50
amp 220 service in your  shop.
Bill Jepson


Make sure the Tig Welder has High Frequency.
Henry.


-- 
The Rotary Engine NewsLetter. Powered by Linux.
ACRE NL web site. http://www.rotaryeng.net
Youtube key word PaulLamar2
Copyright 1998-2009 All world wide rights reserved.