Paul I want to make some p-ports on the Haas this
week. Can you tell me exactly where to mill the
port and what diameter it needs to be. Also what
orientation if any does it need to be in the vise?

Tony

The center of the two inch hole is 8.64 inches up
from the bottom the rotor housing and it is
perpendicular to the vertical axis.

We have some contoured SS p-port tubes left if you
want to buy them. Also some sealing blocks with O-rings.
Check out the bottom of the front page on the website.
Good thing you are doing it on an NC mill as you
can get a better finish on the rotor housing where
the sealing block mounts.

Paul Lamar